Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amsal
it is abbreviation of pounds per square inch gauge.
it means the pressure which is showing this is gauge pressure and not absolute.
| Is This Answer Correct ? | 36 Yes | 1 No |
Post New Answer View All Answers
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
How we connect a instrument with ground, Give brief explanation with help of diagram?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
What is 1:1 redundancy ?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
How to Calibrate Vibration Probe (Axial, Redial) in field
what is the procedure of belt scale calibration?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
What is the constant voltage unit?
kindly sent some demo question and answer
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
what is the procedure of O2 sensor(ABB) calibration?
Can anyone send most commonly asked interview question in Oil & Gas industry
