Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nithi
manishk,you would have asked this question in the reverse
order as why current direction is always denoted in the
direction opposite to the elctron flow..
Because current is a flow of electron (we all
know).electron is a cause & current is the effect .Whenever
voltage is applied across the conductor ,the free electros
starts to flow through it, depend on the polarity of the
applied voltage.But for our theoretical calculations ,we
consider the current in the opposite direction .
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
What are the advantages of the three-phase motor over single phase motor?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
what is the difference b/w ground & virtual ground?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
What determines the thickness of the lamination or stamping?
howmany electrician should maintain for a 1000 kva used plant... in kerala..
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
Where can i get practical knowledge of solar system?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
What is the source of dependent source ?
What is resolver and glass scale in CNC how they work?
When is lag lead compensator is required?
what parameters are should nessary for control technic dc drive(in rolling mills)?
