Interested to Buy Any Domain ? << Click Here >> for more details...
Why induction
motor can not be
operated at
synchronous
speed?? what
would happen if
it is operated
at synchronous
speed??
- 5 Answers
- 25637 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit mohan bhatt
synchronous motor cant be operated on synchronous speed
becoz it if the motor will run on synchronous speed then
there will be no fluxx cut by the conductor of rotor as a
result of which there will be no induced emf in the rotor
nd there is no motion in the rotor , therefore the
synchronous motor will operated in synchronous speed
| Is This Answer Correct ? | 23 Yes | 15 No |
Post New Answer View All Answers
What are the main advantages of bode plot?
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
IN 1000kva transformer where the oil and winding temperature sensors is connected
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
What is synchro?
why normally Generator rating are between 11Kv to 22Kv?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
dg earth connect only in the amf panel or not why
Please define ampere?
If you have an earth with pilecap then your resistance is really low. why and how?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
What is trip and closing coil in cb? Why need of them
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
