Interested to Buy Any Domain ? << Click Here >> for more details...
what is the relation between the size of the machine and
the frequency? (when the frequency increases the size of
machine will increase,why?)
- 2 Answers
- 5042 Views
- I also Faced
- E-Mail Answers
Answer Posted / peter
higher frequency means higher losses...so heat dissipation
requirements are more....size needs be bigger then...
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what are factors to be consider to design a HT & LT motor?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
When we use 3 terminal resistor?
How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
Why are the laminations insulated from each other?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
Why reactors use before incoming of ac vvfd drive?
what are the analog quality input for protection function?what are minimum reqiments?
Why neutral point is consider as zero potential?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
