Why the rating of dc machine is in HP??/
Do reply guys..Its very important......
- 4 Answers
- 5656 Views
- Apollo, I also Faced
- E-Mail Answers
Answer Posted / peter
its not only with DC machines....but others too that are
specified with HP....its just another way of putting it
instead of/ along with KW..
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
What is icu and ics in Acb and how many time icu or ics passes from breaker?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
how to find impedance , mutual indatnce in transmission lines
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
What are the types of the glands and difference between single and double compression type of cable Glands.
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Why does the radius of armature is less than the radius of pole shoe?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
State kirchoff voltage law?
What do you mean by the zone of protection?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
