Why DP level transmitter preferred for closed vessels and
Radar level transmitter for open tanks??
- 2 Answers
- 8385 Views
- I also Faced
- E-Mail Answers
Answer Posted / s vedpathak
In closed vessals, the vessal pressure may vary.this can
cause erratic level feedback.But if DP LT is used it take
into account this vessal pressure as it acts on both LP &
HP side. So LT feedback is purely based on the head due to
vessal fluid.Wet leg & dry leg method can be used depending
on the application.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
send me last 5 years questions asked in rrb chennai, for section engineer
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
Question on maha cement
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
please send data bank of quetions answers on analytical instrumentation.
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
where cascade loop use ?
