Interested to Buy Any Domain ? << Click Here >> for more details...
why we choose 50 or 60 hertz not other value for the power
system?
- 4 Answers
- 8185 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhagya
actually the system will be reliable wen we frequency
between 40to 75hz,but in india we are using 50hz because
copper and core losses depends upon frequeny..nd the other
thing iswe are basically established with tat frequncy in
the time of british ruling.all the machines & euipments are
designed to tat frequncy...nw we cant change..all tat
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
what is draiv work
Define characteristics impedance?
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
How PSV sizing being done
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
how can you calculate fault level ?
difference between the applicability of nortons and thevenin theorem
What happen to generator if i have unbalanced load?
What about electrical Units. discrive in detail
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
