What is the importance of Form B to state Electricity
Boards?
Answer Posted / k.prakashchandra
It is the form for seeking approval from electrical
inspector to charge /commission a new HT line
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
why we change the direction of winding in rotor ?how we make the north and south pole?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
how cables go in and come out for distribution from the feeder pillar box?
How to decide whether A / B / C / D curve type MCB should be used?
What is the function of probe in cro?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
howmany electrician should maintain for a 1000 kva used plant... in kerala..
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
Why generation voltage in thermal power plant is between 11kv to 33kv?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What are the advantages & disadvantages of a group electrive drive?
Why does the rotor rotate?
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?