Interested to Buy Any Domain ? << Click Here >> for more details...
what is sevice settings for mccb?How can be it setted?
- 1 Answers
- 4021 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash parmar
service setting is 95% full load amp as rating.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
why current is constant on d.c?
what is the formula for computing cable tray size & capacity
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
What is the end effect of linear induction motor ??
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
What does ampere turns shows?
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
How to checked frequency drive output voltages?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
where reactive power is used
