differentional compound gernater used for wielding porpose.
why????????//
Answer Posted / k.prakashchandra
to limit the current by lowering the voltage
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can i use the six sigma method which is used in management area, in state estimation of power systems?
how to calculate compresor capacity?
how does the thyistor work in dc drive?
what is the purpose of bypass mode in energy lighting transformer?
HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS
What is the type of feedback used in an op- amp schmitt trigger?
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
Why in ESP Positive earthed
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?
DG cranking voltage?
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?