sir , what happen if we decrease ( approx 3 inch ) the
lenth of shaft in 110KW Induction , three phase motor.
actually a 110KW motor is couppled with star couplling to
120TR compressor. When we doing maintenance in compressor
it is required to skid the motor backword and resulting dis-
alightnment . so we want to change the tyre coupling in
place of existing coupling. so it is required to cut off
the rotor aprox 3 inch form driving side.
Answer Posted / k.prakashchandra
Cutting shaft short will not affect anything including
dynamic balance
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to decide the capacity of accl
How to calculate impedance volt in Transformer?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
why swityard is necessrry requirement in any bis power distributin systems?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
one split ac how can told of this ac which Tr tell me us
Give atleast 20 alternating current apparatus and devices.
What are marginally stable systems?
The loads are connected with phase and ground then why current flow as the loads ?
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
Why power genaration in India is at 50HZ while America its 60HZ
wht is embedded systems? what is new inthis field?