Interested to Buy Any Domain ? << Click Here >> for more details...
How power factor affect on bill explain with example.
- 13 Answers
- 31001 Views
- I also Faced
- E-Mail Answers
Answer Posted / pravin a. mhaske
Power factor affect only on kVA not KW.For e.g. Power
required to run 10kw load is same whatever the Power
factor.But for low power factor current increases & it
will affect on KVA but KW would be the same.
In energy bill KWH will be not affected but charges of
demand chrges will be increased.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
What is nichols chart?
How much voltage we need to apply in 33kv cable during hipot test of cable
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What is the formula to calculate the rating of power cable for three phase current.
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what happen when increase or decrease size of lamp,light.glass.
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What is difference between Sample test and Routine test in safety standard?
what is inverter and converter
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what is the difference between dry and wet type of 132kV terminations. which one is durable
