Answer Posted / ainadz
Basic for close loop.
1 - measure (trasmitter)PV
2 - control (controller)
3 - control valve (MV)
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
ORP sensor working principle?
how to tune siemens sipart electro pneumatic positioner..plz tel me..
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
What is the use of each wire in three wire RTD
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
Gas equation
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
how to measure draft pressure in transmitter pl. give its single line digram
Explain about safety integrated level protection? . How it was differ from other protections ?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
how to check earthing,what is minum ohms for proper earthing
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
