Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sandip upare
Power factor means cos of angle between real power and
active power (kw and kvah)and it should be 90 deg. that
means,power factor is unity.
Now if the angle comes down below 90 deg. the rective power
(kvarh)increases and that means your company pay extra
money for that power which we not use that is only losses
because in low power factor current lead voltage and due to
this copper losses increase and ultimately consumption
increase.
Finally purpose of finding power factor daily in any
company is that
1) To minimise the unwanted consumption
2) avoid heat losses and improving equipment life
3) and Electricity Board gives 7 per. discount in every
monthy bill if we maintain unity PF through out the month
but for that capacitor bank are required as per the load
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is excitation/
what is meant by twilight switches 7 where its applicable ?
what is sevice settings for mccb?How can be it setted?
why co incidence factor considered in transformer sizing?
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
transformer phasor diagram under load explain it?
What is the limitation of kirchoffs law?
What is the relationship between voltage,current & frequency?
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
how does high earth to neutral voltage affects electronic circuit?
How is the gain affected by the introduction of feedback in a control system.
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
