what use can we make of 3rd harmonic component
- 5 Answers
- 11719 Views
- Bhel, General Motors GM, I also Faced
- E-Mail Answers
Answer Posted / bharadwaj.gajula
generally harmonics means ,the unwanted response at the output
....coming to electrically ,the 3rd harmonic components are
eliminated by connecting the alternator 3-phase windings are
in delta or star...but the star connection most preferable
compare delta ,because of the 3rd harmonics components
produces circulating currents,. it results to increase the cu
losses and heat due to that efficiency decreases .so star
connections most preferable
| Is This Answer Correct ? | 20 Yes | 14 No |
Post New Answer View All Answers
What is the formula to calculate the rating of a three phase air circuit breaker
what is the difference between megger and earth resister ??
How the over load setting for HT Motors calculated-provided in Numerical Relay
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
What is installed in PAC that is control the humidity
How to select HT/MV cable size ?
why three phase capacitor takes unbalanced current in capacitor bank?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
What products have you designed which have entered high volume production?
What is current & voltage ? Voltage perform at any load without current or not?
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
How much ph is maintained of water resistance starter for slipring induction motor ?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
