Interested to Buy Any Domain ? << Click Here >> for more details...
what are the problem's will accure in dcs or plc hadware
and what are the solution for it?
- 2 Answers
- 5659 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendra shaha
1)channel failure
2)i/o card fail
3)AI AO channel weak
$)processor card problem
5)bus coupler card problem
6)bulk power supply(BPS)fail
7)DSSR FAIL
8)COMMUNICATION FAIL
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to convert milliampares into flow??
what is sliding spool valves?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
Please can anybody help for control valve sizing step by step procedure?
What is 3 selection available when configure the burnout protection for controller
give me all the details about the interview and which type of question being asked
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
what is KV and XV valve
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
what is span value and zero ? and how set ?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
in differential pressure transmitter,min&max pressure range for hp&lp
what is zero and span ?
what is easiest way to read STL language in PLC?
