Interested to Buy Any Domain ? << Click Here >> for more details...
As we know that during saturation test of CT from secondary
side, the current in secondary shoots up after core
saturation. How core saturation effects the secondary current?
- 2 Answers
- 4556 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Once the saturation is reached ,the back emf will not
increase further in response to the increased applied
voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the distance between each insulator in 33kv transformer and how can it calculate
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
what are the types of electromagnetic forces developed in practical transformer?
What is the abbreviation of NGT panel
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
CBCT selection
what is the current setting for different relay protection for transformer .
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
when it is possible kvrah lead & fundamental kwh be equal in electonic trivector meters (3 ph)
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
difference between high and low impedance BUS BAR relay??
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
what is kvarh? Please define it With calculation General motors ?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
