Interested to Buy Any Domain ? << Click Here >> for more details...
IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN
OUTPUT (THAT MEANS TERMINAL SIDE OF THE INSRUMENTS) I,M
RECEIVING ONLY 6 VOLTS, WHAT IS THE REASON FOR THAT MUCH
VOLTAGE DROP?
- 3 Answers
- 5377 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh ag
Any short circuit inside the instrument may also produce
low output voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
What is the difference between Generator Differential Relay and Transformer Differential Relay?
How can we increase fuel-power ratio of any DG set?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
Where can I get CPWD electrical specifications & Shedule of rates? Please help me
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What are the advantages and disadvantages of short-pitched winding?
hi , i have 150 kw loud and we need 50 m cabil,i want to know wich size cabil we use. thanks
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
