Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Gap Should maintain for HT cables crossing of
LT Cable?
- 2 Answers
- 7479 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajiv
the gap should be bear minimum 300mm from both cable trays
and these are not crossed and if required then the angle
should be of 90 degree.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
A d.c. Shunt motor is found suitable to drive fans because they require?
No load tap changing transformer working
What is the method of estamating of cable, CB,MCB ?
Define ampere
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
what is basic difference betmeen normal & flame proof motor??
What is the difference between diode and a transistor in terms of the direction of current flow?
grr resistance & contrator malt continuous
what maximum range of star & delta in hp or kw ?
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
we need a ntpc previous papers
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
