Interested to Buy Any Domain ? << Click Here >> for more details...
Why is starter necessary for a three-phase induction motor?
- 37 Answers
- 180373 Views
- BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt, I also Faced
- E-Mail Answers
Answer Posted / p k neeraj
at the time of starting of induction motor speed is zero,so
back emf is also zero,as back emf is zero & rotor coil is
sorted(in case of squirrel cage rotor),starting current is
about 5 to 6 times higher then the rated current.so because
of this high voltage drop gets created in the supply line &
equipment connected to this line will experience this.so to
reduce the high current generally we use star delta
starter.at the time of starting we use star connection so
the voltage got reduce then at the time of run we use delta
connection.......
starters also increase the starting torque & improves the
power factor.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what causes contact chatter when there is no demand on the air conditioning unit?
What is the settings of distance protection relay in 400 kv line
A jet of fluid strikes a plate What was the force required to counter it?
What if the difference beween internal and exrteranal LBB?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
1.4 What is meant by CT knee point voltage and how would you determine it
what is auto re-closer?
. How to calculate the Short Circuit Impedance in Transformer? How to calculate the Short Circuit Impedance in Transformer?
what about the power of wattmeter at starting and loding?
132/66kv sub-station procation ?
what is the main difference between power devices and signal devices
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
