Interested to Buy Any Domain ? << Click Here >> for more details...
Is There Any guy give me detail information
regarding "ISO/TS-16949-2002 " /TPM/QMS/SPC/MSA ???
- 3 Answers
- 7201 Views
- I also Faced
- E-Mail Answers
Answer Posted / raghavendra rao h k
TS 16949 is european quality managment system related to
Automotive Industry. Almost all major automobile
manufacturer follow it except japanese companies like
toyota. TPM is a methodology to ensure zero waste attitude
( different industry use this terminology as differently
eg.. total productive maintenance,total perfromance
management etc) in general this is to reduce deviations and
reduce wastages to produce product at lower cost. QMS is
quality management system which deals with all quality
parameters to ensure zero compliance and customer
satisfactions. SPC is statistical process control it is
also a part of TPM here more concentrations on reducing the
variations there by achieving lessr deviations, MSA is
master schedule attainment which deals with planning vs
produced ( alwasy expressed in percentages) this is to the
speed up your product ( availability of the product in
market always to not to loose the customers)& it is for
material management in supply chain sectiions.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHAT IS THE DIFFERENCE B/W LUBE OIL 20 W 40 AND 20 W 40 OIL.
sampile paper for dme in rrb exam
project,planning, equioment erraction &maint format. project,planning&scheduling,bar chart
What is meant by indirect contact heat exchanger?
How we make bend & diffuser from any pipe (it's equation)& how we mark in pipe....
How are voltmeter and am meter connected in the circuit?
What is mean by greenfield project?
1) Any pipe line working fluid may water / steam on it one manual isolation valve suppose one side of valve 6 kg/ cm^2 pressure (i.e. up stream) and other side is “ 0” kg/ cm^2 pressure(i.e. down stream) . So how much Tourqe required for opening the valve in terms of Newton force wheather normal man can open this valve. (for reference pipe nominal bore is 100 NB )
What are you going to inspect or check when you open the crankcase?
Why is heat treatment required?
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
What are the items to inspect after cylinder liner is pulled out
What is mechanism?
What is the use of divider?
How will you measure the eccentricity of the turbine rotor during running
