why should be the frequency is 50 hz only why not others
like 45, 95 56 or anything ,
why should we maintain the frequency constant
if so why it is only 50
- 3 Answers
- 6217 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
You can have the frequency at any frequency you like,
but than you must also make your own motors, transformers
or any other equipment you want to use.We maintain the
frequency at 50hz or 60hz cos the world maintains a standard
at 50 /60hz and the equipments are are made to operate at
these frequency.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
What is creepage distance..... what will be the value for different voltage level
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How do we calculate the Out put voltage of generator, after the excitation is being given?
Why is tan-delta test and capacitor measurement done on alternator?
What is the capacitance values of 132,220,400 & 765 kV current transformer
PIU how does work?
what is per unit calculation?looking for simple and strong explanation thk u
why ct ,cvt should be stored in a vertical position?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
How REF protects transformer alone? explain with diagram.
Why in ESP Positive earthed
What are n circles?
