Interested to Buy Any Domain ? << Click Here >> for more details...
How to find the maximum load(in KW)in a big industry, having
motors,lights,lifts etc..?
- 2 Answers
- 5069 Views
- ME, I also Faced
- E-Mail Answers
Answer Posted / rakesh kumar
First of all calculate the full current in running position
.Then check the incoming voltage and finally check the power
factor.i.e. P.F. and then use the formula:
Total current*1.732*volts*P.F.=Total load(W)
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
How can I known multiplying factor .without multiplying table
Why cables and busbar both needed in LT Panels?
What are gain margin and phase margin?
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
direction of tarbine& genrator
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
what is gas turbine intercooling ?
How can calculate the rating of a alternator for a given specific load with formula
What is control system?
what is the meaning of 0.5ohm Resistance
How to size Air Circuit breaker (ACB)? What is the most important factors?
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
what is the difference between transformer,converter and transducer
