Interested to Buy Any Domain ? << Click Here >> for more details...
What is flow ,level, pressure transmitter ?and units?
- 2 Answers
- 6415 Views
- I also Faced
- E-Mail Answers
Answer Posted / binu
We can use differential Pressure Transmitter for measuring
Flow, Level and Pressure in common. Just need to change
type of measurements. we can choose the units depending
upon the process requirements like mmH2o, mBar etc.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
how to calibrate Necleuonic level transmitter.?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
which processor is used in dcs.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
diff between neutral ,ground,phase , earthing and shielding?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
give me all the details about the interview and which type of question being asked
Capacitance, resistance ( colour coding ), parallel & series circuits.
Definition of reverse and acting controllers:
