Answer Posted / sri krishna
Regulator: it is a device which controls a parameter in some
pre determined steps or simply, regulator allows some
elektrikal quantity,,ina stepped manner vch facilitates to
increase or decreases the magnitude of the parameter.
but, tthe imp.thing to notice is a regulator kan wrk as both
regulator and stabilyzer.
i.e.,the regulator kan also kontrol the parameter to a set
point,implies, if there is any fluktuation inthe magnitude
of the given parameter,the regulatr tends to bring the error
to minimum..by decreasing the dfrnc btwn setpoint and aktual
value.
THIS PROCESS KAN BE DONE IN MANY DFRNT KONTROLLABE STEPS(AT
DFRNT MAGNITUDES)
stabilizer: the stabilizer kontrols the given parameter,and
it reduces the dfrnc btwn the setpoint and aktula value of
the parameter
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
Explain the different regions in frequency response?
What does the term power factor shows?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
Air circuit breaker safety
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
Disadventage of cable-gland earthing if any ?
Difference between drift current and diffusion current?
what is the criteria for selection of conductor used for ehv ac electrical dischrge
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
Vaccum circuit breaker
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
