Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amit
level transmiter(DP transmiter) Consists of a pizoelectric
material which is a resistive material i.e as the pressure
is applied on it the change in dimension takes place, this
application is used in level measurement differential
pressure is applied,from upper tapping point to the
transmition, this end called High tapping point at the
transmitter which is maintained at high pressure so that at
low tapping point will cause changes as the change in level
occurs this level acts as pressure on pizoelectric material
so this causes change in dimension of material which is
electriacally converted into mA by Bridge and transmitted
to the control room.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
how to design orifice plate?what is the equation?
what is interlock system and why we use of this?
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
what is the procedure of belt scale calibration?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Question on maha cement
Explain the working principle of lvdt?
what is sliding spool valves?
What is offset in a control system.
what are the selections available in configuring a burnout protection of a controller? thanks
use of split range ? where it is used ? in which control loop it is used ?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
