Interested to Buy Any Domain ? << Click Here >> for more details...
can i used 400A SFU (for the use of PA fan motor),if my
BUSBAR rating is only 315A?????answer me quickly as
possible.......thanks
- 1 Answers
- 4171 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala_vlsi
first what is your required full load current , you can use
315A Busbar if you load below 315A othervise not possible .
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
State superposition theorem?
Any one can explaination about calibration with rotating sub standards?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
i am gng to visa interview this july i have 4 backlogs gre 1010,toefl 75,pls give me the tips pls pls
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
Name the component u would expect to find in a switchgear assembly?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
what is high - pot test. what's its use?????
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
what is the breaking capacity and making capacity of circuit breaker and how
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
static chagre
