Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / senthil
simple:online tuning.let the system run with no load and
then with low load.
then we can play with the system by varying the
Gain,Integration time, Derivative Gain,Dead band,Tracking value
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What is Erosion in a control valve?
How d.p. Transmitter can be applied to open tank?
What is loop1 and loop2 in MTS LT?
what is span value and zero ? and how set ?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
Why not come out analog output in ABB EL3020 when display show correct value
Lux meter is the measuring device to measure the lux level of lighting fixture. in industrial sector two types of lighting fixture is being used as street lighting purpose 1. HPSV (Sodium) and 2. HPMV (Mercury). HPMV having white light which is an combination of red, blue and yellow colour, while HPSV haivng Yellow lighting. in HPSV red & blue colour will be absent. during measurement of the lux level of HPSV and HPMV fixture. 1. Lux meter can measure the actual lux level of both fixture? 2. or it will show false reading for HPSV fixture light as it has only yellow light present. please give me answer
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
What is zener diode? What is voltage regulator?
