Interested to Buy Any Domain ? << Click Here >> for more details...
What is the tolerance allowable for ISMC 150(c-channel)
as per IS 2062? I want the min and max dimension allowable
in raw material?
- 1 Answers
- 9915 Views
- I also Faced
- E-Mail Answers
Answer Posted / swarup das
1. The tolerance on depth of ISMC 150 Channels shall be +/-
2.5mm.
2. The tolerance on flange width of ISMC 150 Channel shall
be +/-2mm.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is burnt-out point ?
List out the points of diesel generator B check?
Explain why you consider yourself suited for the Position:
why the wear of back tyre takes place more rapidly than front?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
What is the use of multi tester?
How can you identify mild steel, cast iron, and high carbon steel?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
Why gas turbine power plant needs efficient compressor ?
how the efficency of a coupling is calculated?
Explain knurling.
How do you detect earth by lam p?
What happen when too much cylinder oil is injected in the working cylinder?
Explain why re-heater is used in gas turbine
What is the difference between isotropic and anisotropic materials ?
