Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nilkanth tailor
In our home, thier is earthing to protect equipment like
(fridge,tv,computer.etc...).and this earthing wire is going
to ground...in three pin holder one is phase wire another
is neutral wire..and third one is earth..and this earth pin
area is greater then other two pin...coz R is inversley
proportional to the area..if A(area)is greater then R will
be small...and current always passes from lower resistance
path...suppose thier is any Short circuit occured in
fridge..then may be possible that line is directly
connected to that fridge body..and at that time if thier is
no any earthing..we will get shock..but if thier is
earthign provided, then current flows through earth..coz
human resistance is more than earth wire which is used..so
and current pass through earth wire to ground
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
who invented active elements? plz give me the complte details of active elements...
what is the criteria for selection of conductor used for ehv ac electrical dischrge
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
Give the topology of current amplifier with current shunt feedback?
33kv substation lay out details & line to line & line to earth measurements
Why in ESP Positive earthed
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
what is the affect of earth's magnetic field on the frequency used in aircraft???
how to prepare the technical test
why should the primary of transformer be connected in delta in a heat run test?
Why are the laminations insulated from each other?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What are the two segments of nyquist contour.
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
