Interested to Buy Any Domain ? << Click Here >> for more details...
what is the principal of flow transmeter,level trans
meter,presser transmeter?
- 11 Answers
- 28317 Views
- Nestle, Reliance, I also Faced
- E-Mail Answers
Answer Posted / kathirvan.b
Basically TRANSMITTER is a device which transmits the
signal based on its input signal.There is a difference
between the excitation signal and input signals.The
excitation signal may be air signal(less than or equal to
15 PSI)known as pneumatic transmitter OR electrical signal
(+24V DC or 110 V AC) known as electronic transmitter.Then
the output signal will be 3 to 15 PSI for pneumatic
transmitter and 4 to 20 mA for electronic transmitter.
Then the input given to the transmitters may be of FLOW or
LEVEL or PRESSURE.Based on this input given to
transmitter,it produces a output accordind to process input.
STEP I: [LEVEL MEASUREMENT]
The level sensor may of any type (eg:air purging system)
which measures the leves with the appication of ~20 PSI
inlet pressure,because of back pressure the output air
pressure taken back and given to the transmitter,it
produces 4 to 20 mA or 3 to 15 PSI based on the natuire of
transmitter given to the control room.
STEP II: [PRESSURE MEASUREMENT]
The same procedure for each ,transmitter just measures the
process variables ans produces the output based on the
application of process inputs.
FINALLY TRANSMITTERS ARE SAME BUT THE INPUT,EXCITATION
AND OUTPUT SIGNALS MAY VARIED.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how to check earthing,what is minum ohms for proper earthing
Which type of pressure can be measured by primary elements?
i am having information technology branh ....... can i prepare for psu exam
i want to find out iffco get test paper
What is the procedure of calibration of Load cell?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
what does it mean an active front end in vfd plz explain it briefly
What materials are used in thermo wells?
how to control pid
There are many type of control cable like pair,core,tried, What are defination each one
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
What is three element drum level control system why its better than single element?
How many ohms are required for proper earthing?
