What are the different sizes of cables for H.T and L.T side
of supply?
Answer Posted / seema
3COREX2.5SQMM,7CX2.5SQMM,9CX2.5SQMM,12CX2.5SQMM,2CX2.5SQMM,4
CX2.5SQMM
Is This Answer Correct ? | 1 Yes | 11 No |
Post New Answer View All Answers
DG cranking voltage?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
What is the power factor of a transformer at no load?
what is the difference between elcb and rccb ?
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
what is the role of energy meter in distribution system ?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
There is any especial requirement for motor to drive through with VFD?
Electronic circuit
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
can any tell me why slope 40% and 80% is calculated in differential protection?