what will happen if we use earthing inplace of neutral for
domestic energy meter
- 5 Answers
- 7792 Views
- Polyplex Corporation Limited, I also Faced
- E-Mail Answers
Answer Posted / unknown
THE NEUTRAL WILL GET BY-PASS. SUPPLY WILL BE IN ON POSITION
AS THE CIRCUIT WILL BE COMPLETED FROM EATHING BUT THE METER
WILL STOP. CONSUMER WILL BE BENIFITED BUT HE WILL BE
PUNISHED FOR ENERGY THEFT IF TRAPPED
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
how does grading rings & spacers in transmission line works? Working Principle?
how to select electronic timer(Star-Delta) setting for diff. rating motors
What is the meaning of floating point earthing in battery backed systems ?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
how can we calculate the ratio of caustic soda and water in lrs.
1.What is captive power plant? 2.What is national grid?Give brief idea.
what are the stresses in circuit breakers ?
The loads are connected with phase and ground then why current flow as the loads ?
what kind of quetions will ask in BHEL in interview? Plz help me?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
what is difference between speed mode and torque mode in motor?? explain in simple words please.
How many types of losses occur in a transformer?
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
any one can explain what is the size of pvc,armoured, various sizes of powr cable dia?
