Interested to Buy Any Domain ? << Click Here >> for more details...
The capacity of the compressor is considered to be maximum
when the temperature of the air is
a.Maximum b.minimum c.moderate d.
- 10 Answers
- 11493 Views
- I also Faced
- E-Mail Answers
Answer Posted / kunal
100%minimum because if we consider a piston as a ex.if we
increase a temp of flask piston goes upwords,and as we
decrease pistonmoves downword means compresion of certain
gas moilcules/liquid molecules takesplace this proves that
as temperature decrease capacity of compressor will get
increases.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How will you classify sliding contact?
Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?
What is flash steam and flashing phenomena?
What is pneumatic system?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
What are the causes of dirty lubricating oil?
What will be the cause of high temperature in one cylinder of D/E?
thermal engineering
current rating of a 3 phase dg set is 20 amp, but what will be the per phase current for single phase supply?
dear sir i want also last five year rrb chandigarh and allahabad aptitude test question and their answered my id is anshuldhiman83@gmail.com
Temperature closer for brazing operation is-------
Explain how do you calculate cooling energy?
what is the reson in a/c system that TPN TRIPPING
How much stack emmission through your chimney and what is the state govt norms ?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
