Answer Posted / sarad bashyal
demand of power = supply of power -no load sheeding
if supply of the power is higher than demand then at this
time generated power should be decrease in power station by
checking the frequency.
if demand of the power is greater than supply of the power
then there must be cut some feeders in order to balance
the electric system. cutting some load feeders to balance
the electric system is callted load shedding. if we do not
balance the system then anytime frequency will decrease or
increase in the system and finally system will collapsed
and some where it is also called blackout. when system
collapsed/black out that time all the power station which
are connected in grid are are stooped.
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
Starting Time of LT & HT Motor
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
what is is the potential diffrence between two phase ?
how to calculate the breaking capacity of different breakers.
What is the drawback of static coefficients?
how many electricity poles are there and what are the names and their sizes.
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
What are the application of filter?
List examples of voltage source?
If increased the frequency up to 1000 then what changes shows in voltage?
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.