Interested to Buy Any Domain ? << Click Here >> for more details...
how can we run the induction motor at 9000 rpm ,by keeping
frequency constant??
- 2 Answers
- 4559 Views
- I also Faced
- E-Mail Answers
Answer Posted / meenakshi
u gotta increase the frequency from 50Hz to greater than
150Hz. am telling for 2 pole.but i dont think this is
practically possible.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
why only exciting current is shown not primary current in transformer???
How to measure the Harmonic Distortion of UPS ie THD?
what clearance required for 4.5 mva dry type transformer?
whatis the commertial spec. of distribution boards ?
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What does the a,b,c of 95a,95b,95c relays denotes?
Why derivative controller is not used in control systems?
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
what will happen if i connect 12 volt battery with 24 volt battery charger.
how to maintain frenquncy with syncronising sub-station for distribution
What is routh hurwitz stability criterion?
