two bolbs of 100w and 40w respectively connected in series
across a 230v supply.which bolb will glow bright and why?
- 16 Answers
- 59653 Views
- DRDO, PSPCL, Siemens, I also Faced
- E-Mail Answers
Answer Posted / naresh kumar dhal
40 watt bulb.Because it has more voltage drop across it.
| Is This Answer Correct ? | 32 Yes | 14 No |
Post New Answer View All Answers
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
What is boucholz relay and the significance of it in to the trformer?
what are the interview question asked in wind mill about electrical
what is cascade speed control device?and how this device control the speed of motors?
Explain the functioning of diode?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
what are the condition that makes hooter blow?
What is the formula to calculate a three phase alternator
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
Grid fault level [KA]?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
