Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthick
yes because we can light up by using ground
| Is This Answer Correct ? | 22 Yes | 4 No |
Post New Answer View All Answers
What is open delta Xformer? It's adavntages & Use?
what are the reasons of CT circuit faulty in busbar protection scheme?
List the disadvantages of constant k filters?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Why do we use center tap transformer that used with portable tools
What are the functions of different probes used in cro?
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
how rectifier transformer work in electroststic precipetatore(esp?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What is the types of HT motor testing
Any one can explaination about calibration with rotating sub standards?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
