Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ripul ghosh
nowadays 24V DC relays are used compared to 230V what was used before..relays are mainly there to isolate the controller from high power lines,
The signal from the controller will come to the relay and it will get energised to drive the output load.
| Is This Answer Correct ? | 31 Yes | 1 No |
Post New Answer View All Answers
explain key exchanges in all security modes WPA,WPA2,TLS?
In turbine what does term CDP, NI, NH, HSSOC means.
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
is motorized valve closed when power shutoff?
ORP sensor working principle?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
if my flow is 20000 m3/h than which range of DPT i have to use????
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
How do you identify an orifice in the pipeline?
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
what is the difference between profibus and controlnet networking.
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
