Why capacitor bank does not require in DG Set?
- 21 Answers
- 61394 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / sanjay dalvi
IN INDIA, DG DESIGN FOR 0.8 POWER FACTOR,THEN IN UR MIND A
QUESTION MAY ARRISE WHY .8 ONLY??
ANSWER IS THE LOAD IS ALLWAYS INDUCTIVE IN NATURE SO WE
USED 0.8 PF IN DG DEGINING AS A LAGGING PF.
NOW COME TO OUR ACTUAL QUESTION
CONSIDER 1000 KVA DG SET WHICH DELIVER 800 KW O/P POWER
BUT IF IMPROVE POWER FACTOR FROM .8 TO 1 PF THEN
OBEIOUSLY POWER DELIVER INCREGES FROM 800 TO 1000KW
P= V*I*COS $ WE KNOW THAT PF IS 1
LOAD CURRENT IS ALSO SAME FOR
LOAD
HERE POWER INCREASE DIRECTLY EFFECT THE VOLTAGE LEVEL
IF THE VOLTAGE LEVEL GOES BEYOND THE LIMIT IT WILL TRIP
THE AVR SYSTEM OF DG & DG WILL STOP RUNNING
IF WE USE CAPACITOR BANK THEN VOLTAGE LEVEL INCREASE
BEYOND THE LIMIT..SO WE R NOT USEING CAPACITOR BANK.
| Is This Answer Correct ? | 24 Yes | 6 No |
Post New Answer View All Answers
Give two basic speed control scheme of dc shunt motor?
what is feed back and what are feed back amplifiers?
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
What is the transfer function?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
What are the types of the glands and difference between single and double compression type of cable Glands.
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
what is the difference between electrical choke and electronic choke?
What is the distance between each insulator in 33kv transformer and how can it calculate
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
