why is power supplied in 3 phase only? why not in 2 or 4
phases?
Answer Posted / vinai
Because Main generating Alternator has 3phase winding...
And phase angle is 120 degree for each...
So that's way we are supplying 3 phase only not a two
phase or four phase...
If possible to wound an alternator like 2(or)4 phase
then may be it's possible for supplying 2(or)4 phase...
Is This Answer Correct ? | 9 Yes | 20 No |
Post New Answer View All Answers
can indirect loading be called as phantom loading?
how much cable size required for 70 kilowatt load.
How much ph is maintained of water resistance starter for slipring induction motor ?
Why in ESP Positive earthed
Approach of a cooling tower is the difference between temperatures of what factors?
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
how to select electronic timer(Star-Delta) setting for diff. rating motors
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
How to know the Max. current caring capacity of the cable by its size ?
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
Explain what is use of lockout relay in ht voltage?
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.