IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN
OUTPUT (THAT MEANS TERMINAL SIDE OF THE INSRUMENTS) I,M
RECEIVING ONLY 6 VOLTS, WHAT IS THE REASON FOR THAT MUCH
VOLTAGE DROP?
- 3 Answers
- 3828 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If it is the output ,the instrument could be either a
potentiometer or a dc/dc converter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
what is the basic need of domestic loads 1- voltage 2- current
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
Testing procedure of DG alternator stability test
how to calculate IR value of 33KV cable ??
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
what is positive , negative & zero equivalent system resistance
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
What is evaporator & condencer & compressor
Explain and give examples about VCB?
Use of switch mode power converter in real-time basis?
why single phase to grd test in HV cable?why not 2 phase at a time?
