Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manoj
at the time of starting there is high magnitude of current
flowing in the stator winding.this is about 5 to 7 times the
full load current.such large current may harm the
equipment.this high value of current may cause objectionable
voltage drop in the power supply lines feeding the
equipment.so starters are used to minimize the abrupt
increase of the current.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is meant by impedance? difference between high & low impedance ?
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
what is the control circuit for operating the clean room air shower
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
1.how many types of relays? 2.difference between ATS& STS?
Alternator rotor earth fault relay circuit
star delta starter contorl circuit... drawing..
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
WHY RATING OF VCB NOT LESS THAN 630A
describe the fully control circuit diagram of ac drives
briefly explain the main blocks found in a microprocessor based system
What is open loop and control loop systems?
how to calculate compresor capacity?
