Answer Posted / thirudinesh1982
in the motor initially stable when the motor get power then start to rotate at the time starting current 6 times greater than normal current because (there is no back emf at the initial). So we protect the motor from the inrush current to use the starter.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
how to select fuse rating for a 3-phase motor ???
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
how can i improve the power factor in domestic (230v)
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
In what condition the HT fuse breakes?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
explain the functions of main isolation switches
How to calculate the sag of OPGW during stringing???
which is the best institute for PLC,SCADA,DCS in hyderabad
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
how open delta PT works & what is its construction?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
