can we replace d.c.motor by 3 phase induction motor for a
particular application
- 4 Answers
- 5848 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
no we cnn't. because d.c motor are used in ac aswell as
dc.in case of ac it needs 1-phase supply . so we cann't do that
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
star delta starter contorl circuit... drawing..
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
what is diff. between earthing grid,earthing mess, earting grid?
Why 11kv to be generated in generation station
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
In radial network the source is fed from 1 end both ends at central
Which standard we are following earthing resistance test
Why ground terminal is used in pot meter 10k ohms
State ohm’s law?
tell me about roaster switch .& what is the function in transmission & distribution?
dg earth connect only in the amf panel or not why
How would you relate your key competencies to this position?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
what is control supply rating of a machine
