Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tango
basically to obtain the desired voltage at the secondary side
tap is used , the voltage variations at the primary side
results the variations at the secondary side according to
transformation ratio, if the voltage at primary side is more
than rating then no of tuns to be reduced and vice versa if
voltage is less so the no of turns has to be increased so as
to get the exact rated voltage at the primary side.
hence to keep voltage at the rated one needs tap changer for
altering the no of turns. Tap changing is done normally for
+5% to -5%, but some times upto -10% in steps of either 2.5%
or 1.25%.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
What is power distribution criteria for converting single phase unbalanced residential load to 3 phase star connected balance system. Does total KW converted to 3 Phase. Means Divided by root 3.
Safety of dry type transformer
how to maintain frenquncy with syncronising sub-station for distribution
how did the testing of protection relays done through current injection
What is formula calculation size cable wire ?
What was your role in the silicon evaluation/product ramp? What tools did you use?
if i am in front of transmission line how to know that current direction without any equipment
Differentiate between voltage and current feedback in amplifiers?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
