what is the difference between power and distribution
transformer?
Answer Posted / harsha
power means
voltage*current
power t/f(1-phase,3-phase)is designed to change amplitude
of high frequency pulses by the turns ratio and provide
isolation b/wcircuits
distribution transformer is used to change the voltage
levels ex:high to low&low to high
(step up t/f&step down t?f)
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
What is stepper motor. What is its uses?
why output is out of phase in case of common emitter?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
what is metering cum synchronizing panel and how it is used?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
Should power factor be low or high?
Single phase and threephase power calculation
At full load wat is the motor p.f And at no load will is the motor p.f?
how can we design robots
what will happen if OLR CT in all phases are short circuted
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC