Interested to Buy Any Domain ? << Click Here >> for more details...
Why -48V dc power supply using in telecom field?
- 7 Answers
- 23488 Views
- APC, Cisco, I also Faced
- E-Mail Answers
Answer Posted / ratikanta mekap
because all of the electronics equipments used in telecom
field(bts,tx-rx rack,mux etc)are working in dc supply,so
that this is happen.
| Is This Answer Correct ? | 5 Yes | 13 No |
Post New Answer View All Answers
difference between servo motor and synchronous motor
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
what is feed back and what are feed back amplifiers?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
What does Bode plot tell you?
why do we have spikes enough to burn electronic boards, when generators are not grounded
What mean by MLTP
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
v/f drive basic princeple
distribution is maximum done by a)radial b)network c) parallel d)b & c
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
What is A check, B check, C Check & D check for a diesel Generat
what happened when we supply a dc current in dc motor?? can it worked properly?
what is conductor copnstant of ab cable
