Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / stalin raj
we use the DC motors for the fuel handling system and for
ID and PD fans.
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
what are the protecyion of transformer & generators
How to work definite,over pluxing,revers power,OSR relay
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Why compensation is necessary in feedback control system?
how do you test tachos and servos
If a high resistance fault occurs,then what are the changes will happen in the system?
How to calculate wire length,size & current? ( related to control panel)
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
