I want to know the principle of rotating flux transformer.
- 1 Answers
- 2908 Views
- I also Faced
- E-Mail Answers
Answer Posted / meenakshi
u vil be giving 3 phase supply to 3 phase stator winding,a
rotating magnetic field is produced.now rotor is
stationary. i.e, it has not started rotating.only the field
is rotating.now there is flux variation in rotor due to tis
rotating field n hence emf vil be induced in the rotor
bars.becoz of this current vil b flowing in rotor.now main
principle is current carrying conductor placed in a
magnetic field vil experience a torque.n thus rotor
rotates. this much only i kno.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
1.4 What is meant by CT knee point voltage and how would you determine it
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
State angle criterion.
what is the function of Moulded case circuit breaker, why it is called Moulded?
what are the basic insulation levels & what its Unit
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
What is pi controller?
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
any one can explain the stages of a knee point which is taken during ct magnetising curve.
Please define ohm’s law for a.c (alternating current)?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
